Roland Texart RT-640 - Accommodating to the Types and Condition of Media; Adjusting Print Head Height to Match Media Thickness

91
4
Advanced Functions
Accommodating to the Types and Condition of Media
Adjusting Print Head Height to Match Media Thickness
Procedure

Press .

Press several times to display the screen shown
at left.
Press
.

When the screen on the left is displayed, open the front
cover.

Move the height-adjustment lever to adjust
the head height.
When the lever is moved to the [High] direction, the
buzzer sounds twice. When it is moved to the [Low]
direction, the buzzer sounds once.

Close the front cover.
The print-head carriage moves to the original position, and then the
screen shown on the left appears.

Press to go back to the original screen.
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the
chance of contact with the print heads. When using such media, adjust the print head height to "HIGH."
Setting the print head height to “HIGH” may aect printing results, for example by producing coarser printing
results than when “LOW” is set. If this happens, refer to the pages indicated below.
 P. 88"Correcting for Misalignment in Bidirectional Printing", P. 37"Performing the Initial Adjustment (Correcting
for Misalignment in Bidirectional Printing More Precisely)", P. 97"Preventing Soiling of the Media and Dot Drop-Out"
/'07
*'#&*'+)*6
*'#&*'+)*6
*+)*.19
Height-adjustment lever
Move firmly, until it stops.
High
Low
/'07
*'#&*'+)*6