97
Description
This makes the setting for distance from the left or right media clamp to the corresponding left or right edge
of the printing area. You can select either "5 mm," "10 mm," or "25 mm." Setting this to "5 mm" lets you expand
the printing area.
P. 128"Maximum Printing Area and Margins"
Note, however, that when you are using transparent media, setting this to "5 mm" may result in printing on
top of the media clamps.
Default Setting
[SIDE MARGIN]: 10 mm
Preventing Soiling of the Media and Dot Drop-Out
Procedure
Press .
Press several times to display the screen shown
at left.
Press
.
Press several times to display the screen shown
at left.
Press
.
Press or to select a setting.
NONE
Automatic cleaning is not performed.
PAGE
Automatic cleaning is performed every time before printing starts.
PRDC CL. (JOB)
Automatic cleaning is performed when the cumulative printing time
reaches the value you set here. However, if this time is reached during
printing, automatic cleaning is performed before the next printing
operation starts. Because printing is not paused, uneven color issues
due to paused operation do not occur.
PRDC CL. (TIME)
Automatic cleaning is performed when the cumulative printing time
reaches the value you set here. When this time is reached during
printing, printing pauses and so colors may be uneven.
Press to conrm.
Press to go back to the original screen.
To Next Page
Loading...
