4. Assembly and Ink Filling
34
}
Attach the drain bottle and press .
~
The (approximate) remaining time for the procedure is displayed on
the screen.
When the screen shown in the gure at left is displayed,
make sure the drain bottle is not overowing with dis-
charged uid, and then press
.
When the screen shown in the gure appears, lling with ink is
nished.
(+..+0)+0-
%*'%-
&4#+0$166.'
5'6725*''6
After this, the next step is to adjust the feed adjusters and the media holder adjusters. This
procedure will be performed by a Roland DG service technician, so leave it up to them.
* For information on how to install the take-up system, refer to the take-up system user’s manual.
* If using the TUC-3, it is necessary to make adjustments by removing the springs and other
parts from the control box and frame of the TUC-3. For details, refer to TUC-3 documentation.
* If using the TUC-3, it is recommended that you use the backward setting for the take-up unit.
To Next Page
Loading...
