Roland TR-626 - Page 19

Step 3
Step 4
Basic Operation
To raise the pitch, press the Up Key. To lower the pitch, press the
Down Key.
UP
... Pitch goes up
DOWN
·.. Pitch goes down
The pitch of drum voices can be set between -7 to +7. If the TR
-626 is not in the Play mode, this setting can be done while checking
the volume with the Main Key.
If you would like to change other drum voices' pitches, repeat Steps
2 and 3.
While pressing the Shift Key again, push the Pitch Key to leave the
pitch mode.
PITCH will no longer be displayed.
* The pitch can be adjusted in every mode ( see page 21) except while
writing an accent.
* The actual variable range of pitch in each drum voice differs from each
other. Changing pitches of a voice may result in change of tone.
(How to initialize the level and the pitch)
While holding
To initialize the TR-626's level and pitch settings to the values set
in the factory, do the following :
Make sure that the unit is turned off, then turn the unit on while
holding the Level Key down.
LEVEL
D
MiHill#M
POWER
down, turn on OFF ON
1-+[!Il]]]i
19