Roland TrueVIS SG2-540 - Daily Print Head Check; Printing Tests and Normal Cleaning

Prinng Tests and Normal Cleaning
1. Perform a prinng test.
Before you carry out actual prinng, perform a prinng test to ensure no dot drop-out or dot displacement occurs.
If dot drop-out or dot displacement occurs, perform cleaning of the print heads (normal cleaning).
MEMO
• This operaon is unnecessary if you will only perform cung.
• When performing prinng tests successively, you can select "SCAN" (vercal prinng) or "FEED" (horizontal prinng) as the print
posion for the 2nd and later tests in comparison to the 1st test.
Procedure
1. Load the media.
2. Press [FUNCTION].
3. Press [▼], then [▶] to display the screen shown below.
CLEANING
TEST PRINT
4. Press [ENTER].
Prinng of the test paern starts.
5. Check whether there is dot drop-out or dot displacement in the test paern.
Missing blocks indicate dot drop-out. Collapsed or inclined blocks indicate dot displacement.
6. If you have opened the front cover, close it.
If no dot drop-out or dot displacement occurs, this operaon is nished. Press [FUNCTION] to go back to the
original screen.
RELATED LINKS
・ User's Manual（hps://webmanual.rolanddg.com/SG2-640）
Daily Print Head Check
14 2. Regular Maintenance