Roland TrueVIS SG2-540 - Basic Maintenance Knowledge; Types and Timing of Maintenance

Types and Timing of Maintenance
To use this machine under its opmal condions, it is important to perform the appropriate maintenance at the
appropriate mes.
Regular Maintenance
These are the maintenance items that are required on a daily basis.
Timing Category Item Page
Aer daily operaons Cleaning the machine Media path P. 9
Knife carriage roller P. 10
When the discharged uid is
ready to overow
Disposing of discharged uid Disposal due to a message P. 12
Disposal due to the drain bole capacity P. 13
When dot drop-out or dot dis-
placement occurs
Cleaning of the print heads Normal cleaning P. 14
Medium cleaning P. 16
Powerful cleaning P. 17
Manual cleaning P. 18
If colors are uneven Eliminang uneven colors Shaking the pouch trays P. 26
Advanced Maintenance
These maintenance methods consume a large amount of ink. Thoroughly read the explanaon in the User's Man-
ual, and then perform the operaon at the appropriate point in me.
Timing
Category Item
When uneven colors are not resolved Eliminang uneven colors, dot drop-
out, and dot displacement
Super Cleaning
When manual cleaning is not eecve
Replacing Consumable Parts
These items are for replacement of consumable parts. Thoroughly read the explanaon in the User's Manual, and
then perform the operaon at the appropriate point in me.
Timing
Category Item
When a replacement message ap-
pears
Replacing consumable parts
• Wipers
• Tray pad
• Blade
• Separang knife
Replacing the wiper and the tray pad
Cleaning the wiper tray
When a cung edge becomes dull Replacing the Blade
Replacing the separang knife *1
Some Roland DG Corporaon models refer to this as the "separang knife."
RELATED LINKS
・ User's Manual（hps://webmanual.rolanddg.com/SG2-640）
Basic Maintenance Knowledge
6 1. Introduction