3. Attach the media holders.
Procedure
1. Position the motorized media holder as shown in the figure.
Be sure to pass this holder behind the stand.
2. Place the two shafts on the arms.
3. Attach the motorized media holder to the shafts.
(1) Pass the front shaft through the motorized media holder.
(2) Catch the motorized media holder on the rear shaft.
4. In the same manner, attach the left media holder to the shafts on the left side of the printer as seen from
its front.
1. Assembly and Ink Filling
24 Installation
To Next Page
Loading...
