Output Is Not Possible in These Situations
• The machine does not run when a cover (front, left, or right) is open.
• Data from the computer is not accepted when [Load media.] is displayed.
• Output does not start while [Heater warm up in progress. Please wait.] is displayed.
• On menu screens where [Menu operation in progress: Press [Home] to enable output.] is displayed, out-
put doesn't start even when data is sent from the computer. When you return to a menu item where output
is possible or tap to return to the home screen, output starts.
Points that must be observed
• Never open a cover (front, left, or right) while output is in progress. Doing so interrupts printing.
• When you are performing printing, clamp the edges of the media with the media clamps. Otherwise, the
edges of the media may warp and catch on the print heads.
• During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub
against the print heads, which may result in a paper jam or damage to the heads.
• Keep the loading lever raised when the machine is not in use.
When not using the machine, remove any media and store it in a suitable environment.
• If the machine is left with the media loaded, the media may be damaged, which may adversely affect
printing. When not using the machine, remove any media and store it in a suitable environment.
IMPORTANT
RELATED LINKS
・ P. 164 Setting the Print Heater Temperature
・ P. 166 Setting the Dryer Temperature
・ P. 172 Switching Off the Print Heater and Dryer Together
Starting Output
Printing and Cutting Method 133
To Next Page
Loading...
