[Correction Value (Feed)] (correction value of the media feed direction): 0.00 mm
[Correction Value (Scan)] (correction value of the print head movement direction): 0.00 mm
• You can also make corrections of printing and cutting positions at the same time without removing the me-
dia.
RELATED LINKS
・ P. 187 Correcting the Misalignment of Printing and Cutting with Crop Marks (Concurrent Test for
Printing and Cutting with Crop Marks)
Correcting the Reading Sensor
Depending on the characteristics of the media, such as reflectivity and colors, the machine may not be
able to read the crop marks. In such cases, correct the sensor for reading crop marks.
Procedure
1. Load the media.
2. Tap .
3. Tap [Media Settings]>[Other Media Settings]>[Multi Sensor Adjustment].
4. Tap [Execute].
5. Perform the operations shown below according to the [Adjustment Result].
• If [Successful] is displayed on the operation panel, proceed to the next procedure.
• If [Failed] is displayed on the operation panel, the following causes are possible, so take coun-
termeasures and redo the correction.
Cause
Countermeasures
The lighting in the room where the printer is installed or
vicinity of the printer is too bright.
Adjust the lighting in the room.
Correction failed for some reason. Redo the correction.
Crop marks cannot be recognized on the media being
used.
Change the media type.
There is ink on the multi sensor because, for example,
the media strikes it immediately after printing.
Contact your authorized Roland DG Corporation dealer.
6.
Tap to go back to the original screen.
Accurately Adjusting the Settings for Cutting with Crop Marks
194 Optimizing the Output Quality
To Next Page
Loading...
