5. Tap [Execute].
The cutting carriage moves to a location where wiper replacement is possible.
6. When [Open the right cover.] appears, open the right cover.
The procedure is displayed on the operation panel.
• Tap or to check the procedure.
• If you complete the work without viewing the instructions, tap [Finish All].
MEMO
7. Touch the location shown in the figure to discharge any static electricity.
8. Replace the wipers.
(1) Detach the old wipers.
Using the tweezers, unhook the wipers, and then pull them up. Using the tweezers to press
on the hook in the hole on the wiper makes it easier to remove the wiper.
(2) Attach the new wipers.
Place the inclined end of the wiper on the back side of the machine. If the wiper is installed
with the incorrect orientation, appropriate cleaning will not be possible.
Be sure to attach the wiper to the hook. Failure to do so may result in dot drop-out or other
problems.
Replacing Parts for Maintenance
258 Replacing Consumable Parts
To Next Page
Loading...
