RELATED LINKS
・ SG3-540/300 Setup Guide (https://downloadcenter.rolanddg.com/ "Setup Guide)
Is the LAN routing appropriate?
Check whether or not the network routing is appropriate. Try connecting the computer and the machine to
the same hub or connecting them directly using a cable. If this makes it possible to perform output, it
means the problem may be in the network itself.
Are the LAN settings correct?
If the cable connections are secure and no problem is found in the network itself, make sure that the IP
address and other such settings are appropriate. The settings on both the machine and the computer must
be appropriate. Redo the settings, checking to ensure that the IP address does not conflict with the IP ad-
dress for another device on the network, that the port setting for the software RIP specifies the IP address
set on the machine, that the settings have no typing errors, and for other such problems.
RELATED LINKS
・ P. 216 Viewing Printer Information
・ SG3-540/300 Setup Guide (https://downloadcenter.rolanddg.com/ "Setup Guide)
Did the software RIP end abnormally?
Make sure the software RIP is running correctly, then switch the sub power switch off and back on.
RELATED LINKS
・ VersaWorks manual (https://downloadcenter.rolanddg.com/VersaWorks6)
Is an [Ink Pouch Tray Error] displayed?
When an [Ink Pouch Tray Error] appears on the display screen, output data cannot be accepted. If there is
data that has not yet been output remaining in the machine, output resumes when the error is cleared. If
there is unsent data in the computer, output resumes when the data is resent.
When ink runs out
Replace the ink pouch with a new one.
The printer unit does not run
Machine Problems 297
To Next Page
Loading...
