Roland TrueVIS VG-640 - Correcting the Misalignment of the Printing and Cutting Positions

Advanced Cutting Settings
4
Advanced Functions
139
I
Press [ ] or [ ] to select the correction value.
Set the correction value of the cutting carriage movement direction.
SCAN SETTING
0.00% -0.10%
Important
When you are performing printing followed by cutting, be sure to set the correction value to "0.00%."
If you do not set it to "0.00%," the printing and cutting positions will be misaligned.
J
Press [ENTER] to conrm your entry.
K
Press [MENU] to go back to the original screen.
Description
The movement distance of the media changes subtly depending on the media's thickness. This means that
the length of a line when cut may dier from the length setting in the data. Enter the correction values when
you want to accurately align the lengths of cut lines when performing only cutting.
Default Settings
[FEED SETTING]: 0.00%
[SCAN SETTING]: 0.00%
Correcting the Misalignment of the Printing and Cutting Positions
Note: When performing this setting, be sure to set the value of [CALIBRATION] on [CUTTING MENU] to "0.00%."
" P. 138 "Performing Distance Correction During Cutting"
1. Perform the preparations before the correction.
A
Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
" P. 143 "Viewing the Automatic Environment Correction Function Settings"
B
Perform bidirectional adjustment.
" P. 124 "Correcting for Misalignment in Bidirectional Printing"
2. Perform a printing test.
A
Press [MENU].
B
Press [ ] to display the screen shown below.
MENU
CUTTING MENU