Roland TrueVIS VG-640 - Using Media Flanges for Paper Tubes (Cores) with an Internal Diameter of 2 Inches

Other Useful Functions
4
Advanced Functions
156
C
Press [ ], then [ ] to display the screen shown below.
SUB MENU
TEST PRINT POS
D
Press [ ] to display the screen shown below.
TEST PRINT POS
SCAN SCAN
E
Press [ ] or [ ] to select "FEED."
TEST PRINT POS
SCAN FEED
F
Press [ENTER] to conrm your entry.
G
Press [MENU] to go back to the original screen.
Description
When performing printing tests successively, you can select "SCAN" (vertical printing) or "FEED" (horizontal
printing) as the print position for the 2nd and later tests in comparison to the 1st test.
If you are using the optional media take-up system, test prints will be printed with the "SCAN" orientation
regardless of this setting.
Default Setting
[TEST PRINT POS]: SCAN
Using Media Flanges for Paper Tubes (Cores) with an Internal Diameter of 2 Inches
Note: The media anges for paper tubes (cores) with an internal diameter of 2 inches are optional items. For
information about purchasing them, contact your authorized Roland DG Corp. dealer.
Media ange for 2-inch media
Insert the pin.
Line up the ridges
and grooves.
Pull out the pin.
If it is dicult to pull out, use a pair
of pliers or a similar tool.
End cap