181
6
Troubleshooting
Other Problems
The Printer Unit Doesn't Run
Is the power switched on?
Switch on the printer's main power, and then press the sub power
switch and make sure the sub power switch lights.
P. 24 "Turning the Power On"
Is [SETUP] lit?
Output is not performed when [SETUP] is not lit. Lower the loading lever.
P. 57 "Step 6 : Starting Output"
Is a cover open?
Close the front, left, and right covers.
Is the top menu displayed?
Top menu
W1100mm
If the top menu isn't displayed, output doesn't start even when data
is sent from the computer. To go to the top menu, press [MENU].
P. 57 "Step 6 : Starting Output"
Is [PAUSE] lit?
When [PAUSE] is lit, operation is paused. To resume, press [PAUSE].
[PAUSE] turns o and output resumes.
P. 77 "Pausing or Canceling Output"
Is a message displayed on
the screen?
P. 185 "A Message Appears"
P. 187 "An Error Message Appears"
Are the cables connected?
Connect the cables securely.
Setup Guide
Is the network routing ap-
propriate?
Check whether the network routing is appropriate. Try connecting
the computer and the machine to the same hub, or connecting
them directly using a crossover cable. If this makes it possible to
perform output, it means the problem may be in the network itself.
Are the network settings
correct?
If the cable connections are secure and no problem is found in
the network itself, make sure that the IP address and other such
settings are appropriate. The settings on both the machine and
the computer must be appropriate. Redo the settings, checking
to ensure that the IP address does not conict with the IP address
for another device on the network, that the port setting for the
software RIP species the IP address set on the machine, that
the settings have no typing errors, and for other such problems.
Setup Guide
P. 166 "Viewing System Information"
Did the software RIP exit
abnormally?
Make sure the software RIP is running correctly, and then switch
the sub power switch o and back on.
Roland VersaWorks Quick Start Guide
To Next Page
Loading...
