Roland TrueVIS VG-640 - Basic Printing Method; Printing Flow

28
2
Basic Operation
Basic Printing Method
Printing Flow
Step 1 : Loading Roll Media (Setup of Media) (P. 29)
First, load the media on the printer. Load the media correctly according to the explanations.
Step 2 : Initial Adjustment (Correcting for Misalignment in Bidi-
rectional Printing) (P. 37)
Perform the printing correction. Be sure to perform this step the rst time you use the machine.
Step 3 : Batch Settings (P. 39)
You can set the minimum of items necessary for output as a batch.
Step 4 : Setting the Base Point (P. 53)
Set the base point in order to determine the output area.
Step 5 : Printing Tests and Normal Cleaning (P. 54)
Before you carry out actual printing, ensure no dot drop-out occurs. If dot drop-out occurs, perform
cleaning.
Step 6 : Starting Output (P. 57)
Send data from the computer and output it from the printer.
The above procedure is the basic ow of printing operations. The rst time you print data, follow this procedure.
Once you are used to the machine, congure advanced settings to obtain printing that matches your purpose.
If the machine is used for a long time, a variety of maintenance operations may also become necessary.