Roland TrueVIS VG2-540 - Page 250

2. Start the super cleaning menu.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
SUB MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
SUB MENU
INK CONTROL
4. Press [▶] to display the screen shown below.
INK CONTORL
SUPER CL.
5. Press [▶].
6. Check for the group with dot drop-out or dot displacement by viewing the results of the prinng test.
The space from "A" to "B" is group A. The space from "B" to the right side is group B.
MEMO
If the prinng-test results are dicult to interpret
Check the results in a bright locaon, changing your line of vision. It is visible using the reecon of the light.
7. Select the group of print heads to clean.
(1) Press [◀] or [▶] to select the group of print heads that is not to be cleaned.
SUPER CL.
AB
(2) Press [▲] or [▼] to get rid of the group display.
SUPER CL.
A
(3) Repeat steps 1 and 2 to display only the group of print heads that requires cleaning.
Only the displayed groups will be cleaned. If A and B are displayed, they will both be cleaned.
8. Press [ENTER] to conrm your entry.
9. When the screen shown below appears, remove the drain bole and discard the discharged uid.
Handling Severe Dot Drop-out and Dot Displacement
3. Advanced Maintenance 249