Roland TrueVIS VG2-540 - Page 84

3. Set the blade force.
For high-quality cung, perform a cung test to check the cung quality for the media and adjust the blade
force.
Procedure
1. Press [▶] to select "NEXT".
HEAD HGT LOW
CHANGE [NEXT]
2. Press [ENTER] to conrm your entry.
3. Press [▶] to select "NEXT".
CALIBRATION
SET [NEXT]
4. Press [ENTER] to conrm your entry.
5. Press [▶] to select "NEXT".
MEDIA GAP ADJ.
[SET] NEXT
6. Press [ENTER] to conrm your entry.
7. Press [◀] to select "YES."
CROP-CUT ADJ.
SET [NEXT]
8. Press [ENTER] to conrm your entry.
9. Press [◀] to select "YES."
CUT FORCE
[SET] NEXT
10. Press [ENTER] to conrm your entry.
The test paern is cut.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
11. Peel o the two cut shapes (a circle and a square).
12. Check how the two shapes peel o.
• Two shapes are peeled o together/backing paper is also cut
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Two shapes are peeled o separately
Press [▶] to select "DONE".
Cutting Output
2. Cutting Method 83