Roland TrueVIS VG2-540 - Installing.the.cutting.tool; 2 Installing the Cutting Tool; Step.1:.Assembling.the.cutting.tool; Step 1: Assembling the Cutting Tool

52
2.Installation
CAUTION
Be sure to perform operaons as specied by the instrucons, and never
touch any area not specied in the instrucons.
Failure to observe this instrucon may cause the machine to move suddenly,
resulng in injury.
CAUTION
Never touch the p of the blade.
Doing so may result in injury. The cung performance of the blade will also
be impaired.
Step 1: Assembling the Cutting Tool
Required items
Blade holder Blade Pin
Procedure
A
Insert the pin.
Insert the pin to the posion where its end scks out about 3 to 5 millimeters (0.12 to 0.20 in.).
Pin
B
Insert the blade.
Insert the blade into the hole.
Tip
Blade
2. Installing the Cutting Tool