Roland TrueVIS VG2-640 - Sheet too Small Continue; Data Error Canceling; Sheet Set Error Set Again; Some MID.pinchs Not Set Right

1. To connue performing output without correcng this, press [ENTER]. At this me, the crop marks and the
poron extending beyond the prinng area are not output. To stop output, stop sending data from the com-
puter, and then raise the loading lever. Make the prinng area wider, for example, by replacing the media with
a larger piece of media, and then send the data again.
2. Make the horizontal-direcon (scan-direcon) size of the data at least 65 mm (2.6 in.). To connue performing
output without correcng this, press [ENTER]. At this me, the data is output without prinng the crop marks.
To stop output, stop sending data from the computer, and then raise the loading lever. Change the size of the
data, and then send the data again. There is no limitaon on the size of the data in the media-feed direcon.
SHEET TOO SMALL CONTINUE?
The size of the data is larger than the prinng area of the loaded media
To connue performing output without correcng this, press [ENTER]. At this me, the poron extending beyond
the prinng area is not output. To stop output, stop sending data from the computer, and then raise the loading
lever. Make the prinng area wider, for example, by replacing the media with a larger piece of media, and then
send the data again.
DATA ERROR CANCELING...
Output was stopped because a problem was found in the received data.
Operaon cannot be connued. Compleng the data cancellaon will clear the message. Check for a problem with
the connector cable or the computer, or if the printer data has any defects (a color is designated that cannot be
output, etc.). Once the problem or defect has been corrected, send the data again.
SHEET SET ERROR SET AGAIN
1. [ENTER] was pressed even though the loading lever was not lowered.
2. [EDGE DETECTION] is set to "ENABLE", but transparent media was loaded.
1. Lower the loading lever, and then press the [ENTER] key.
2. Raise the loading lever, set the [EDGE DETECTION] menu item to "DISABLE", and then reload the media.
RELATED LINKS
・ P. 30 "Setup of Roll Media"
・ P. 40 "Setup of Sheet Media"
・ P. 146 "Using Transparent Media"
SOME MID.PINCHS NOT SET RIGHT
Although the user has forgoen to place the middle pinch rollers, [ENTER] was pressed aer lowering the load-
ing lever.
Without further acon, the setup will not be completed. Place the middle pinch rollers over all the grit rollers
within the media width. Aer that, lower the loading lever, and then press [ENTER]. Failing to place the middle
pinch rollers correctly may cause unstable transport of media, leading to reduced prinng quality.
When you press [ENTER], the message disappears and the operaon connues.
PINCHROLL ERROR LOWER PINCHROLL
This message appears when the loading lever was raised during inializaon or aer the media was loaded.
Press any key to clear the error. Alternavely, the error is cleared automacally aer a short wait. Never move the
loading lever while output is in progress.
PINCHROLL ERROR INVALID LEFT(RIGHT)POS
The le (right) pinch roller is posioned at a locaon where it cannot pinch the media.
Error Messages
5. Messages on the Operation Panel 301