2. Select the media.
Procedure
1. Tap [Setup].
The registered media is displayed in a list.
2. Select the media name to use.
3. Tap [Next].
4. The [Setup Method] screen appears. Select whether to use the take-up unit.
5. Tap [Start Setup].
The cutting carriage moves and detects the width of the media and the positions of the media
clamps. This operation is called initialization.
6. When [Printing Area (Width)] screen appears, use the following procedure to configure the settings.
The media selected in step 2 is media whose printing area was set manually when registered as new media.
The printing area must be set manually each time, so the [Printing Area (Width)] screen appears.
MEMO
(1) Tap [Change].
The [Set the right edge of the printing area within the area specified by the pinch roll-
ers.] screen appears.
(2) Hold down
to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside
(B) from the left edge of the right pinch roller.
(3) Tap [OK].
The [Set the left edge of the printing area within the area specified by the pinch rollers.]
screen appears.
Setup of Registered Media
Basic Operations 99
To Next Page
Loading...
