When output is complete, separate the media, take up the media manually, and then remove the media.
Handling roll media is an operation that must be performed by 2 persons or more, and care must
be taken to prevent falls.
Attempting to lift heavy media in a manner that taxes your strength may cause physical injury. Also, if dropped, such
items may cause injury.
WARNING
Procedure
1. Lower the dancer roller toward the rear.
2. Close the front cover.
3. With the media held down, tap [Sheet Cutting] on the operation panel.
4. Select [Sheet Cutting] and tap [Execute].
Give Attention to the Media Composition
• For some types of media, separation is not possible.
• Some types of media may remain on the platen after separation. If the media remains on the platen, re-
move it by hand.
IMPORTANT
5. Use the MANUAL switch to take-up the media.
Removing Media from the Take-up Unit
Basic Operations 107
To Next Page
Loading...
