7. Set the correction values in the feed direction of the media (the feed direction) and the direction of
print head movement (the scan direction).
(1) Tap or next to [Correction Value (Feed)] to set the correction value in the feed direc-
tion of the media (the feed direction).
(2) Tap or next to [Correction Value (Scan)] to set the correction value in the direction
of print head movement (the scan direction).
8. Tap [Save].
The correction values are saved.
9. Tap [Execute] next to [Printing Test 1 (Misalignment Check)].
Printing Test 1 is printed and cut. If the printing and cutting lines are aligned, adjustment is com-
plete. If further adjustment is needed, tap
or next to [Correction Value (Feed)] and
[Correction Value (Scan)] to fine-tune the printing and cutting position, and then [Save] the val-
ues.
Default settings
• [Correction Value (Feed)] (correction value of the media feed direction): 0.00 mm
• [Correction Value (Scan)] (correction value of the print head movement direction): 0.00 mm
MEMO
10.
Tap to go back to the original screen.
Preparations for Printing and Cutting Output
134 Printing and Cutting Method
To Next Page
Loading...
