8. Set the correction values in the feed direction of the media (the feed direction) and the direction of
print head movement (the scan direction).
(1) Tap
or next to [Correction Value (Feed)] to set the correction value in the feed direc-
tion of the media (the feed direction).
(2) Tap or next to [Correction Value (Scan)] to set the correction value in the direction
of print head movement (the scan direction).
9. Tap [Save].
The correction values are saved.
10. Tap [Execute] next to [Printing Test 1 (Misalignment Check)].
Printing Test 1 is printed and cut. If the printing and cutting lines are aligned, adjustment is com-
plete. If further adjustment is needed, tap
or next to [Correction Value (Feed)] and
[Correction Value (Scan)] to fine-tune the printing and cutting position, and then [Save] the val-
ues.
• Default settings
[Correction Value (Feed)] (correction value of the media feed direction): 0.00 mm
[Correction Value (Scan)] (correction value of the print head movement direction): 0.00 mm
• Depending on the changes in the condition of media caused by laminating and the loading position of the
media before cutting, the positioning of cutting may be misaligned. In such cases, correct the misalignment
of printing and cutting with crop marks.
MEMO
11.
Tap to go back to the original screen.
RELATED LINKS
・ P. 195 Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for Print-
ing/Cutting with Crop Marks)
Preparations for Output with Crop Marks
How to Cut with Crop Marks 143
To Next Page
Loading...
