After printing crop marks and performing post-processing such as laminating, load the media again. Use
this section to check the settings required for cutting output.
Step 1: Loading Media with Crop Marks
Procedure
1. Load the media on which crop marks have been printed.
Place the front left and right crop marks so they are straight and aligned with the blade protector
(A).
Ensure that the crop marks are not angled by more than 5 degrees. Crop marks cannot be read at higher an-
gles.
IMPORTANT
2. Finish the media setup and check that the home screen is displayed.
This completes the setup of the media with crop marks. Proceed to Step 1: Switching Off the Print
Heater and Dryer(P. 124).
RELATED LINKS
・ P. 32 Setup of New Media
・ P. 69 Setup of Registered Media
Preparations for Cutting Output
146 How to Cut with Crop Marks
To Next Page
Loading...
