Roland TrueVIS VG3-540 - Using the Correction Functions; Automatically Making Required Adjustments

To Next Page

To Previous Page

To optimize the output quality, it is effective to use some correction functions.

Automatically Making Required Adjustments

To optimize the output quality, corrections must match the media and printing conditions.

Depending on the printing conditions, the ink landing position may be misaligned and the movement dis-

tance may change subtly during media feeding. Automatically correct these issues to match the media.

First, print a test pattern. Then read this pattern with the multi sensor and automatically enter the cor-

rection values.

Executing automatic correction prints a test pattern, reads this pattern, and enters the correction values

for the following operations.

• Multi sensor adjustment (adjusting to the optimal condition the sensor used in correction)

• Media gap adjustment (correcting the ink landing position)

• Feed correction (to reduce horizontal bands)

Procedure

1. Load the media.

2. Close the front cover.

3. Tap .

4. Tap [Media Settings]>[Printing Settings]>[Batch Automatic Correction].

5. Tap [Execute].

Test patterns are printed and correction values are entered for the following operations.

• Multi Sensor Adjustment

• Feed Correction

• Media Gap Adjustment

6. Tap [OK] when the completion screen appears.

7. Perform the operations shown below according to the [Result].

• If [Successful] is displayed on the operation panel, tap to go back to the original

screen.

• If [Failed] is displayed on the operation panel, carry out manual adjustment.

Related product manuals