Using Sticky Media
This setting is used to peel off the media before starting printing when using media that sticks easily to
the platen. This setting is effective to prevent media jams.
Note, however, that peeling off the media may cause unstable media feed. Leave this menu item set to
[Disable] unless you specifically need to change it.
Procedure
1. Load the media.
2.
Tap .
3. Tap [Media Settings]>[Other Media Settings]>[Media Sticking Prevention].
4. Select [Enable].
5. Tap [Save] to confirm your entry.
6. Tap to go back to the original screen.
• Default setting: [
Disable]
MEMO
Configuring Settings to Match the Properties of the Media
Optimizing the Output Quality 161
To Next Page
Loading...
