Using an Auxiliary Drying Unit (DU3)
This setting is required when using an auxiliary drying unit (DU3). When [Extended Dryer] is set to [Ena-
ble], the temperature is set to the same temperature as the printer's dryer. When [Blower Fan] is set to
[Enable], the blower fan turns during printing.
Procedure
1. Load the media.
2.
Tap .
3. When using [Extended Dryer], configure the settings as shown below.
(1) Tap [Preferences]>[Extended Dryer].
(2) Select [Enable].
(3) Tap [Save] to confirm your entry.
4. When using [Blower Fan], configure the settings as shown below.
(1) Tap to go back to the original screen.
(2) Tap [Blower Fan].
(3) Select [Enable].
(4) Tap [Save] to confirm your entry.
5. Tap to go back to the original screen.
• Default settings
• [Extended Dryer]:[Disable]
• [Blower Fan]:[Disable]
• For information about the DU3, contact your authorized Roland DG Corporation dealer or visit our website
(http://www.rolanddg.com/).
• For details on how to use the DU3, refer to its documentation.
MEMO
RELATED LINKS
・ DU3-64/54 User's Manual
Adjusting the Ink-drying Method
178 Optimizing the Output Quality
To Next Page
Loading...
