Check item Result Setting item Adjustment
Check the shape of the
square you have peel-
ed off.
The corners are not rounded
and do not have "horns."
[Blade Offset]
No change
The corners are rounded. Increase
The corners have "horns." Reduce
6. Tap or to change the settings.
Display screen (cutting conditions) Setting details
Default set-
tings
[Blade Force] Set the force (pressure) of the blade. 50 gf
[Cutting Speed] Set the speed of cutting. 30 cm/s
[Blade Offset] Set the blade offset. Enter the listed offset value for the blade.
The offset value for the included blade is 0.250 mm (9.8 mil).
0.250 mm
(0.010 in.)
[Rise Movement Speed] Set the blade's up speed during cutting (the speed at which the
blade travels when it moves to the next cutting line after cut-
ting one cutting line). If the media comes loose during no-load
feed and the blade damages the surface of the media, reduce
the speed.
30 cm/s
7. Tap [Save] to confirm your entry.
8. Tap to go back to the original screen.
Accurately Adjusting the Cutting Settings
180 Optimizing the Output Quality
To Next Page
Loading...
