Roland TrueVIS VG3-540 - Cutting to Make It Possible to Cut Corners Attractively (over Cut)

Cutting to Make It Possible to Cut Corners Attractively (Over Cut)
Cutting the corners of the border of the cutting line slightly longer makes it possible to cut the corners
attractively.
This is effective when using laminated or thick media, or non-resilient media. It also has the effect of
making stickers easier to peel off.
Procedure
1. Load the media.
2. Tap .
3. Tap [Media Settings]>[Cutting Settings]>[Over Cut].
4. Tap [Enable].
5. Tap [Save] to confirm your entry.
6. Tap to go back to the original screen.
• Default setting: [
Disable]
• The cutting start point is not over cut.
MEMO
Accurately Adjusting the Cutting Settings
184 Optimizing the Output Quality