Correcting the Misalignment of the Printing and Cutting Positions during Cut-
ting
This method pauses a cutting operation to correct the misalignment of the cutting positions (A) when this
misalignment is found during cutting after printing. The correction values set here are applied to the me-
dia settings currently set up.
If the printing and cutting positions are misaligned, normally adjust the positions while checking a test
pattern.
Procedure
1. During cutting, tap [Pause].
The cutting operation is paused.
2. Tap .
3. Tap [Media Settings]>[Cutting Settings]>[Print & Cut Position Adjustment].
4. Determine the correction value for the cutting position.
To decide a correction value
In the following figure, move the solid line (A), representing the current cutting position, to the dashed line
(B).
MEMO
Accurately Adjusting the Settings for Printing and Cutting
190 Optimizing the Output Quality
To Next Page
Loading...
