Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate
Test for Printing/Cutting with Crop Marks)
Due to changes in the thickness of media caused by laminating and misalignment of the loading position of
the media before and after cutting, the positioning of printing and cutting may be misaligned even when
you are using crop marks. Make corrections for misaligned printing and cutting for the media you are using
and its condition.
In this test, so as to create the same conditions as the actual operation, print only the crop marks, remove
the media, load the media again, and then cut the media.
1. Adjust the misalignment of the ink landing position.
Procedure
1. Load the media.
2. Tap .
3. Tap [Media Settings]>[Printing Settings]>[Media Gap Adjustment].
4. Select [Simple Correction (Auto)] and tap [Next].
5. Tap [Execute].
The test pattern is printed and the media gap is adjusted automatically.
6. Tap [OK] when the completion screen appears.
7. Perform the operations shown below according to the [Result].
• If [Successful] is displayed on the operation panel, tap
to go back to the original
screen.
• If [Failed] is displayed on the operation panel, manually adjust the media gap.
RELATED LINKS
・ P. 155 Manual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjust-
ment)
Accurately Adjusting the Settings for Cutting with Crop Marks
Optimizing the Output Quality 195
To Next Page
Loading...
