Roland TrueVIS VG3-540 - Changing the Units of Measurement

Changing the Units of Measurement
Use the following procedure to set the units of measurement displayed on the display screen of the opera-
tion panel.
Procedure
1. Tap
.
2. Tap [System Information]>[Units].
3. Tap [Length].
4. Select the unit.
5. Tap [Save] to confirm your entry.
6. Tap [Temperature].
7. Select the unit.
8. Tap [Save] to confirm your entry.
9. Tap to go back to the original screen.
• Default settings
• [Length]: mm
• [Temperature]: °C
MEMO
Managing the Basic Settings of the Printer
220 Optimizing Operation Management