5. Tap [Execute].
Cleaning will start. The status is displayed as [Normal cleaning in progress.] at the top of the op-
eration panel.
On completion, you will return to the original screen.
6. Perform a printing test again.
7. Check to make sure the dot drop-out or dot displacement has been corrected.
If the problem persists, try performing normal cleaning again. If the printer has been used for a
long period, dot drop-outs may not be fixed even after performing normal cleaning two or three
times. If this is the case, clean using a different method.
RELATED LINKS
・ P. 118 Performing a Nozzle Drop-out Test
・ P. 251 When Normal Cleaning Is Not Effective
When Dot Drop-out or Dot Displacement Occurs
250 Advanced Maintenance
To Next Page
Loading...
