Take-up Unit Use Conditions
Never pull the media with excessive force.
If the media is pulled with excessive force, the protection function will activate and cause an error. Make
sure to observe the following to prevent the media from being pulled with excessive force.
• Do not operate the manual switch on the take-up unit while leaving media secured with the load-
ing lever.
It may cause an error because the media is pulled with excessive force.
Never use the automatic separation function for media.
If automatic cut-off of media is set in the software RIP, the media will be cut off after each page is print-
ed. When continually printing and taking up multiple pages, disable the automatic cut-off function in the
software RIP. If the media is separated, take-up will be interrupted at that point.
Perforated sheet cutting can be set with the software RIP. With this type of cutting, the media is not separated, so the
take-up unit can be used.
MEMO
About the Paper Tube
Paper tubes are consumable items.
Paper tubes are components that wear out. Although replacement timing will vary depending on use,
watch the condition of the paper tube and replace at an appropriate time so that the media can be taken
up in good working order.
Use the paper tube of the media you are using. To purchase the included paper tube, contact your author-
ized Roland DG Corporation dealer or visit our website (http://www.rolanddg.com/).
Take-up Unit
Basic Information 25
To Next Page
Loading...
