2. Perform a printing test to check the results.
Procedure
1. Load the media.
P. 32Setup of New Media
2.
Tap
[Nozzle Drop-out Test] on the home screen.
3. Tap [Execute] next to [Printing Test].
Printing of the test pattern starts.
4. Check whether there is dot drop-out or dot displacement in the test pattern and whether its uneven col-
ors have been eliminated.
5. If you have opened the front cover, close it.
If no dot drop-out or dot displacement occurs and if there are no uneven colors, this operation is
finished. Tap to go back to the original screen.
If the dot drop-out or dot displacement location is different, perform medium cleaning another two or
three times.
If this problem is not fixed, contact your authorized Roland DG Corporation dealer.
Handling Severe Dot Drop-out and Dot Displacement
Advanced Maintenance 263
To Next Page
Loading...
