Roland TrueVIS VG3-540 - Page 278

• If you complete the work without viewing the instructions, tap [Finish All].
6. Detach the blade holder.
7. Replace the blade.
(1) Press the pin (A) to push out the old blade (B).
(2) Insert a new blade (C).
Orient the tip of the blade (D) correctly.
A
B
C
D
8. Install the blade holder into the cutting carriage.
OK Not OK
9. Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
Replacing the Blade/Separating Knife
Replacing Consumable Parts 277