Machine Problems
The Print Heads Do Not Move ....................................................................... 307
What to Do First ................................................................................ 307
If the Print Heads Still Do Not Move ......................................................... 307
The printer unit does not run....................................................................... 309
Is the power switched on? .................................................................... 309
Is [Output possible.] displayed? ............................................................. 309
Are any covers open? .......................................................................... 309
Is the message [Output is currently paused.] displayed on the screen? ............. 309
Is a message displayed on the screen? ...................................................... 309
Are the cables connected?.................................................................... 309
Is the LAN routing appropriate? .............................................................. 310
Are the LAN settings correct? ................................................................ 310
Did the software RIP end abnormally? ...................................................... 310
Is an [Ink Pouch Tray Error] displayed? .................................................... 310
The Media Heating System Doesn't Warm Up..................................................... 312
Is the media loaded?........................................................................... 312
Is [Heater Power] turned on? ................................................................ 312
Is the temperature of the room too low?................................................... 312
Cannot Separate the Media ......................................................................... 313
Is the separating knife installed? ............................................................ 313
306
Machine Problems
To Next Page
Loading...
