Roland TrueVIS VG3-540 - Messages on the Operation Panel

Messages on the Operation
Panel
Messages ............................................................................................... 315
[When output, cleaning, and other operations are completed, discard the
discharged fluid.] ....................................................................... 315
[The time for manual cleaning has arrived.] ............................................ 315
[The time for wiper replacement has arrived.]......................................... 315
[The time for wiper tray cleaning has arrived.] ........................................ 315
[Print head protection mode has activated.]............................................ 315
[Replace the cleaning liquid pouch.]...................................................... 316
[Install the cleaning liquid pouch.] ........................................................ 316
[The extended dryer is not connected.] ................................................. 316
[The time for ink mixing has arrived.].................................................... 316
[Operation of the take-up unit stopped.] ................................................ 316
[Place the middle pinch rollers over all the grit rollers.]............................. 316
[Install the media clamps correctly.] ...................................................... 317
[Media clamps could not be detected.]................................................... 317
[The LAN cable is not connected.] ........................................................ 317
[Connection is requiring too much time. Manually setting the IP address
will improve the connection speed.] ............................................... 318
[The media could not be detected automatically. Manually set the printing
area.] ...................................................................................... 318
Error Messages ........................................................................................ 320
[Ink Pouch Tray Error] ........................................................................ 320
[Cover Open Error]............................................................................ 320
[Media End Error] ............................................................................. 320
[Pinch Lever Error] ........................................................................... 321
[Media Loading Error] ........................................................................ 321
[Drain Bottle Error] ........................................................................... 321
[Crop Mark Detection Error] ................................................................ 321
[Unable to Fill Wiper Cleaning Liquid] .................................................... 322
[Pinch Roller Error] ........................................................................... 322
[Print Head Height Mismatch] .............................................................. 322
[Insufficient Media Width]................................................................... 322
[Motor Error] ................................................................................... 323
[Print Head Dry-out Error] .................................................................. 323
[Low Temperature Error] .................................................................... 323
[High Temperature Error].................................................................... 324
[Pump Stop Error] ............................................................................. 324
[Cleaning Error (Ink Pouch Tray)] .......................................................... 324
[Cleaning Error (Drain Bottle)].............................................................. 324
[Take-up Unit Communication Error]...................................................... 324
[Service Call] ................................................................................... 325
[Software error] ............................................................................... 325
314
Messages on the Operation Panel