RELATED LINKS
・ P. 32 Setup of New Media
・ P. 69 Setup of Registered Media
[Install the media clamps correctly.]
This message appears when the media clamps are not placed at the predetermined positions.
Check the loading status of the media and that the pinch rollers have been positioned correctly, and then
correctly set the media clamps at the ends of the media.
RELATED LINKS
・ P. 32 Setup of New Media
・ P. 69 Setup of Registered Media
[Media clamps could not be detected.]
This message appears when the media clamps cannot be detected because they are hidden by the me-
dia.
Check the loading status of the media and that the pinch rollers have been positioned correctly, and then
correctly set the media clamps at the ends of the media.
This message appears when the media clamps cannot be detected because their parts that are read
are dirty with, for example, ink.
Use cleaning liquid and a cleaning stick to clean the white parts on the media clamps.
It may not be possible to detect the media clamps because the multi sensor is dirty with ink due to
reasons such as the media striking it immediately after printing.
Install the media clamps correctly and clean their parts that are read. If this message still appears, con-
tact your authorized Roland DG Corporation dealer.
RELATED LINKS
・ P. 32 Setup of New Media
・ P. 69 Setup of Registered Media
[The LAN cable is not connected.]
This message appears when the machine and a computer are not connected with a LAN cable.
Properly connect the LAN cable.
Messages
Messages on the Operation Panel 317
To Next Page
Loading...
