Roland TrueVIS VG3-540 - [Connection Is Requiring too Much Time. Manually Setting the IP Address will Improve the Connection Speed.]; [The Media Could Not be Detected Automatically. Manually Set the Printing Area.]; Area.]

[Connection is requiring too much time. Manually setting the IP address will
improve the connection speed.]
This message appears when automatic IP address acquisition is enabled and the machine connects to a
network on which no DHCP server exists while this automatic acquisition is in progress.
Connect to a network on which a DHCP server exists or disable automatic IP address acquisition and set a
fixed IP address.
[The media could not be detected automatically. Manually set the printing
area.]
This message appears when media with high reflectance is set up. Manually set the printing area.
Procedure
1. Tap [OK] on the screen displaying the above message.
2. Tap [Change].
The [Set the right edge of the printing area within the area specified by the pinch rollers.]
window appears.
3. Hold down to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B)
from the left edge of the right pinch roller.
4. Tap [OK].
The [Set the left edge of the printing area within the area specified by the pinch rollers.] win-
dow appears.
5.
Hold down to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B)
from the right edge of the left pinch roller.
Messages
318 Messages on the Operation Panel