The cutting conditions and the service life of the blade change according to the media and the operating
environment, even when you're using identical blades. The service life also differs according to the type of
blade. A rough guide is shown below.
Blade Media Blade force
Amount of blade offset
(amount of blade tip
correction)
Blade life (general
guide)
*1
ZEC-U5032 General Signage Vinyl 30 to 100 gf 0.25 mm (0.01 in.) 8,000 mm (26,246.7 ft.)
ZEC-U5025
General Signage Vinyl 30 to 100 gf 0.25 mm (0.01 in.) 4,000 mm (13,123.4 ft.)
Fluorescent Vinyl 120 to 200 gf 0.25 mm (0.01 in.) 4,000 mm (13,123.4 ft.)
Fluorescent Vinyl 100 to 200 gf 0.25 mm (0.01 in.) 4,000 mm (13,123.4 ft.)
*1 The values for "Blade life" are estimates for when an identical type of media is used.
When uncut areas remain even when the blade force is increased to a value that is higher than the values
shown in this chart by 50 to 60 gf, replace the blade.
About the Blade
Main Specifications 339
To Next Page
Loading...
