• Hold the media holders from the outside and move them.
• Adjust the positions so media is taken up in the center of the paper tube.
(2) Secure the left and right media holders.
5. Follow the procedure below to secure the media on the paper tube.
Secure the media in the [Take-up Direction] set in step 2 of 1. Install the media on the media
holders.(P. 69).
(1) While pulling the media so that it does not sag, secure the center of the media on the paper tube
with adhesive tape.
(2) While pulling the media from the center toward the outer edges, secure the left and right edges of
the media on the paper tube with adhesive tape.
• When using the FORWARD setting
Setup of Registered Media
Basic Operations 87
To Next Page
Loading...
