• When using the BACKWARD setting
6. Tap [OK].
A small amount of the media is fed out.
7. Lower the dancer roller toward the front.
8. Tap [OK].
When printing and cutting or just cutting, rewind the media from the take-up device to slacken the media.
If sufficient media is not wound on the paper tube immediately after setup, this operation may not be performed well,
lowering the cutting quality and preventing continued take-up. When performing cutting immediately after attaching
the media to the paper tube, first feed enough media to carry out take-up a few times and set the base point.
IMPORTANT
Setup of Registered Media
88 Basic Operations
To Next Page
Loading...
