Roland V-Accordion FR-18 diatonic - 9 Highlighting some Practical Functions; How to Balance the Various Sections

Highlighting some practical functions
V-Accordion FR-18 diatonic
r
31
9. Highlighting some practical functions
This chapter discusses some useful functions, like changing your keyboard layout (tablature), changing your playing
tonality, using the metronome, checking the battery status, and so on.
How to balance the various sections
Here is how to change the volume balance between the
bass/chord and treble sections.
1. Press and hold the [SET] register (it flashes
slowly).
The treble keyboard no longer plays.
2. Press button number 3 of the treble key-
board to select the function that allows you
to change the volume balance between
bass/chord and treble sections.
You are now in Function mode—and the Balance
parameter is already selected.
The [SET] register flashes rapidly and the treble key-
board can now be used to play notes.
The lit treble register indicates which preset is cur-
rently selected.
3. Use registers [1]~[4] to select one of the
following settings:
These are presets prepared at the factory. If the bal-
ance sounds right with one of these settings, you are
done, otherwise, continue with step (4).
NOTE
When you increase the volume of the Bass&Chord section,
the volume of the Treble section is automatically decreased
correspondingly and vice versa. See also “Treble/
Bass&Chord Balance” on p. 43.
4. (If necessary) Press the [DEC] button to
move the balance towards the Bass & Chord
section, or the [INC] button to to move the
balance towards the Treble section.
Button no. 3
Button number 3
Treble/Bass&Chord balance
Treble
register
Value
On a DJ mixer, this setting
would look like this…
1
60 (Bass &
Chord)
2
0 (Equal
balance)
3 30 (Treble)
4 60 (Treble)
0306060 30
0306060 30
0306060 30
0306060 30
FR-18d_UK_1.fm Page 31 Wednesday, December 15, 2010 2:16 PM