Saving your settings (User Programs)
V-Accordion FR-18 diatonic
r
35
10. Saving your settings (User Programs)
Your FR-18 diatonic contains 4 User Program memories where you can store the settings listed below. Working with
those memories has the advantage that you can recall frequently used settings at the press of a button. The User Pro-
gram settings also include the “address” of the last Set you selected.
The following settings are saved to the User Programs:
Using User Programs during your
performance
1.
Press the [USER PROGRAM/DEC] button to
enter User Program mode (the button
lights).
The treble register corresponding to the last User
Program you selected lights.
2.
Press the treble register ([1]~[4]) that is
assigned to the User Program whose set-
tings you want to use.
The register you press lights red.
3.
Press the [USER PROGRAM/DEC] button
again to exit User Program mode.
The [USER PROGRAM/DEC] button goes dark. At this
point, the FR-18 diatonic returns to the settings you
were using before selecting User Program mode.
Saving your current settings
1.
Press and hold the [USER PROGRAM/DEC]
button (it flashes).
One treble register lights to indicate the User Pro-
gram that is currently in use.
2.
Press the treble register ([1]~[4]) that is
assigned to the User Program memory
where you want to save your settings.
The register you press lights and the [USER PRO-
GRAM/DEC] button lights steadily.
Set
Number of the current Set
Treble section
Register
Octave setting
Orchestra/Organ
Register
Octave setting
Level
Bass & Chord section
Register
Orchestral Bass
On/Off
Register
Level
Orchestral Chord
On/Off
Register
Level
Drum mode
On/Off
Drum Set number
Level
Chord Mode
Full Chord, –3^
Key
Selected key
Tablature
Selected tablature number
Orchestra Mode
Dual, Solo
FR-18d GB.book Page 35 Wednesday, December 15, 2010 1:54 PM
To Next Page
Loading...
