Miscellaneous
V-Accordion FR-18 diatonic
r
51
14. Miscellaneous
Restoring the factory defaults
You can reset the FR-18 diatonic to its factory settings,
which means that your own settings (including the User
Programs) are replaced by the settings the FR-18
diatonic contained when you first got it. Consider
archiving your settings on a USB memory before load-
ing the factory defaults.
1.
Switch off the FR-18 diatonic (see p. 21).
2.
Hold down treble registers [1] and [4] while
switching the FR-18 diatonic back on.
3.
Wait until treble registers [1]~[4] start
flashing, then release them.
The FR-18 diatonic starts the initialization process.
While the initialization is in progress, the
[ORCH. BASS], [ORCH. CHORD] and [LEFT REGISTER]
buttons as well as the four treble registers flash.
When it is complete, the four treble registers stop
flashing.
NOTE
This operation does not erase the expansion sounds.
Recovering the factory User Set
data
There may be times when you no longer need your User
Set settings and prefer to use the Set data the FR-18
diatonic contained when you first bought it. To do so,
proceed as follows:
1.
Press and hold the [SET] register (it flashes
slowly).
The treble keyboard doesn’t play.
2.
Press button “31” on the treble keyboard to
select the “Load factory Set” parameter.
See page 42 for the location of that button.
3.
The [SET] register flashes quickly and regis-
ters [1], [2], [3] light red or green:
Green means that the corresponding Set memory
contains no User Set data and therefore doesn’t need
to be initialized.
Red means that Set memory in question contains
User Set data and can be initialized if you like.
4.
Press treble register [1], [2] or [3] to select
the Set memory you want to initialize.
The FR-18 diatonic loads the factory data for the
selected Set memory.
5.
Press the [SET] register twice to exit Func-
tion mode.
Red
Green
–User– –factory– –factory– –not used–
FR-18d GB.book Page 51 Wednesday, December 15, 2010 1:54 PM
To Next Page
Loading...
