Roland V-Bass - COSM AMP and Effects Settings

22
Chapter 2. Creating sounds
COSM AMP settings
Here’s how to make COSM AMP settings. Make these
settings as desired.
1. Press [COSM AMP].
fig.2-04
fig.2-05
2. Press [F1] (ON/OFF).
3. Turn the VALUE dial to switch COSM AMP on/off.
4. Press [F4] (TYPE), and use the VALUE dial to select the
COSM AMP type.
COSM AMP “TYPE” (p. 53)
• CONCERT 810
• FLIP TOP
• B-MAN
• VO DRIVE
• SESSION
• T.E.
• BASS 360
• SUPER FLAT
• AC BASS
• MS STACK
• Hi-GAIN STACK
• METAL STACK
5. Press [PAGE ].
* Each time you press [PAGE ], you will move to the next
parameter setting screen. You can also move to the setting
screen for the next section by pressing [COSM AMP].
6. Press [F1]–[F6] to select the parameter that you want to
edit, and use the VALUE dial to edit it.
7. Edit the parameters until you get the sound you want.
8. If you want to save the edited settings, perform the
Write procedure (p. 30).
* If you do not want to save, press [EXIT] to return to the Play
screen.
EFFECTS settings
Here’s how to make effect settings. Make these settings as
desired.
1. Press [EFFECTS].
fig.2-06
fig.2-07
2. Press [F1]–[F3] to switch each effect on/off.
* Each time you press [PAGE], you will move to the next effect
setting screen. You can also move to the next effect setting
screen by pressing [EFFECTS].
* In page 4, press [F1] or [F3] to select a parameter, and [F6]
(SET PDL) to assign “FV LEVEL” to the built-in EXP pedal.
3. Turn the VALUE dial to select “CUSTOM” or
“PRESET.”
4. If you want to edit the effect parameters in more detail,
press “EDIT [F4]–[F6].”
5. Press [F1]–[F6] to select the parameter that you want to
edit, and use the VALUE dial to edit the value.
6. Edit the parameters until you get the sound you want.
7. If you want to save the edited settings, perform the
Write procedure (p. 30).
* If you do not want to save, press [EXIT] to return to the Play
screen.