Roland V-Bass - Pedal Function Settings

24
Chapter 2. Creating sounds
Pedal function settings
(EXP/CTL/GK VOL/GK SW)
Make these settings if you want to use the EXP pedal or CTL
pedal of the V-Bass, a pedal connected to the V-Bass, or an
external MIDI device to control parameters while you
perform. For more details, please refer to PEDAL ASSIGN (p.
62) section.
* If you want to use a pedal to control the parameters of an
effect, you must first turn that effect “ON.”
Specifying the function of the
V-Bass’s EXP pedal
1. Press [PEDAL ASSIGN].
fig.2-10
2. Press [F1] (ON/OFF) to switch the EXP pedal function
on/off.
fig.2-11
3. Turn the VALUE dial to select “CUSTOM” or PRESET.
4. If you wish to edit further, press [F4] (EDIT).
fig.2-12
5. Press [F1] (TARGET), and use the VALUE dial to select
the target.
* Press [F2] (NEXT GROUP) to cycle through these choices:
COSM BASS, COSM AMP, the various effects, and FX
BYPASS on/off.
6. Press [F4] (MIN), and use the VALUE dial to specify the
minimum value.
7. Press [F5] (MAX), and use the VALUE dial to specify
the maximum value.
8. If you want to save the edited settings, perform the
Write procedure (p. 30).
* If you do not want to save, press [EXIT] to return to the Play screen.
Specifying the function of the
V-Bass’s CTL pedal
1. Press [PEDAL ASSIGN].
fig.2-10
fig.2-11
2. Press [F2] (ON/OFF) to switch the CTL pedal function
on/off.
fig.2-13
3. Turn the VALUE dial to select “CUSTOM” or PRESET.
4. If you wish to edit further, press [F5] (EDIT).
fig.2-14
5. Press [F1] (TARGET), and use the VALUE dial to select
the target.
* Press [F2] (NEXT GROUP) to cycle through these choices:
COSM BASS, COSM AMP, the various effects, and FX
BYPASS on/off.
6. Press [F4] (MIN), and use the VALUE dial to specify the
minimum value.
7. Press [F5] (MAX), and use the VALUE dial to specify
the maximum value.
8. Press [F6] (MODE), and use the VALUE dial to select
the mode.
NORMAL:
The value will be MAX while you press the CTL
pedal, and MIN when you release the CTL pedal.
TOGGLE: The MIN value and MAX value will
alternate each time you press the CTL pedal.
9. If you want to save the edited settings, perform the
Write procedure (p. 30).
* If you do not want to save, press [EXIT] to return to the Play screen.