Roland V-Bass - Reflecting the Position of the EXP Pedal and GK VOL When a Patch Is Recalled; Adjusting the Depth and Range of the Built-In EXP Pedal; Specifying the Function of the VALUE Dial; Preventing Accidental Operation During a Performance

37
Chapter 3. System settings
Chapter 3
Reflecting the position of the EXP pedal
and GK VOL when a patch is recalled
Here you can specify whether the current positions of the
EXP pedal and GK VOL will be reflected when a patch is
recalled.
1. Press [SYSTEM].
2. Press [F3] (PEDAL).
3. Press [F6] (EXP/GK VOL HOLD), and use the VALUE
dial to turn the pedal function on/off.
fig.3-11
ON: The current values of the controllers will be
reflected when a patch is recalled.
OFF: The patch will be recalled with the settings it had
when written. (The current values of the
controllers will be ignored.)
4. Press [EXIT] several times to return to the Play page.
Adjusting the depth and range of
the built-in EXP pedal
Here you can specify the depth (minimum value/maximum
value) of the built-in EXP pedal.
1. Press [SYSTEM].
2. Press [F3] (PEDAL).
3. Press [PAGE ] to access page 2.
fig.3-12
4. Release the built-in EXP pedal, and press [F4] (SET).
The display will ask “ARE YOU SURE?”
fig.3-13
* When you see “More Release!” on the display, please check again
if the built-in EXP pedal is released to the minimum position.
5. To make the setting, press [WRITE].
* If you decide not to make the setting, press [EXIT] to return to
the Play screen.
6. Depress the built-in EXP pedal, and press [F6] (SET).
The display will ask “ARE YOU SURE?”
* When you see “More Release!” on the display, please check again
if the built-in EXP pedal is released to the minimum position.
7. To make the setting, press [WRITE].
* If you decide not to make the setting, press [EXIT] to return to
the Play screen.
8. Press [EXIT] several times to return to the Play page.
Specifying the function of the
VALUE dial
Preventing accidental operation
during a performance
1. Press [SYSTEM].
2. Press [F5] (DIAL).
fig.3-14
3. Turn the VALUE dial to select the function of the
VALUE dial.
P.NUMBER&VALUE:
In the Play screen the pedal can be used to select patches,
and in the edit screens it will function as the value dial.
VALUE ONLY:
The pedal will function only as the value dial in the edit
screens.
4. Press [EXIT] several times to return to the Play page.