68
Chapter 5. Parameter guide
5STR-Lo2:
fig.5-05
5STR-Hi1:
fig.5-06
5STR-Hi2:
fig.5-07
6STR:
ig.5-08
DIRECTION
Specify the direction in which the divided pickup is installed.
SCALE
710 mm–940 mm, SHORT, MEDIUM,
LONG (JB/PB), EXTRA LONG
Specify the scale length of your bass.
Measure the length from the nut to the bridge of the highest
string (normally G or C string) of your bass.
Then, specify the value within 710 –940 mm, or select one of
the 4 presets listed below.
GK PU PHASE
(GK pickup phase)
Specify the phase of the divided pickup and the normal
pickup of your bass.
* The sound of the divided pickup is mixed with the sound of the
normal pickup so that the setting can be made accurately.
* Set this to “NORMAL,” and if this causes the lower range to
be attenuated, set it to “INVERSE.”
S1/S2 POSITION
This exchanges the S1 and S2 switches of the GK-2B.
GK CONNECTION
The V-Bass automatically detects whether there is a GK
connection, and will switch its settings so that functions
other than COSM BASS (e.g., COSM AMP and EFFECTS) can
be used even when only the BASS INPUT is connected.
If you are using a pickup other than the GK-2B and this
function does not work correctly, please try the following
settings.
PU
<––>
BRIDGE
(pickup<––>bridge) 0 mm–50 mm
Specify the distance between each GK pickup and the bridge.
* If the TYPE is set to PIEZO, this setting will be ignored.
SENSITIVITY
0–100
Adjust the input sensitivity of each GK pickup.
SETTING NAME
Specify a name for the GK settings.
NORMAL The pickup is installed with the cable extending
from the bridge side.
REVERSE The pickup is installed with the cable extending
from the neck side.
SHORT 760 mm
MEDIUM 812 mm
LONG (JB/PB) 864 mm
EXTRA LONG 914 mm
NORMAL The phase will not be changed.
REVERSE The phase will be reversed.
NORMAL The switches will not be exchanged.
REVERSE The S1 switch and S2 switch will be exchanged.
AUTO Detect automatically, and switch the settings appro-
priately. (Recommended)
ON Always use the GK connection settings.
OFF Always use the BASS INPUT settings.
Move the cursor to the left.
Move the cursor to the right.
Move the cursor to the end.
SPACE Insert a space.
DELETE Delete a character and shift everything that fol-
lows to the left.
A, a, 1, ■ Switch between entering uppercase letters, low-
ercase letters, numbers, and characters
To Next Page
Loading...
